Philco model 18 (code 121) - HELP!
Posts: 4,896
Threads: 54
Joined: Sep 2008
City: Sandwick, BC, CA
The other electrolytic can, the one under the chassis, can be replaced by three poly film caps if desired as they are small values. Whether they would fit inside the original can is another story but they are available and will survive much longer then replacement electrolytic caps. They can be purchased from Radio Daze and Mauser.
With regards to a positive side going to ground this is something to be careful with, there are some filter caps that have a common positive with two negative sides where a bias resistor network and speaker field coil will be connected in series with the negative side, the field coil acts as a filter choke and the resistors as a bias voltage divider.
Regards
Arran
(This post was last modified: 02-08-2013, 10:56 PM by Arran.)
Messages In This Thread
RE: Philco model 18 (code 121) - HELP! - by Arran - 02-08-2013, 10:49 PM
Users browsing this thread: 2 Guest(s)
|
Recent Posts
|
Model 70 Cabinet Trim
|
musar ,
Well if you have any more questions feel free to post away .
Sincerely Richardradiorich — 08:56 PM |
Model 70 Cabinet Trim
|
Although I have not made any cabinets or cabinet parts for a couple of years, I still have some parts left over, includi...Steve Davis — 06:26 PM |
philcorepairbench.com - shadow-meter
|
Thanks Ron.fenbach — 02:43 PM |
Model 70 Cabinet Trim
|
Thank you, Gary. Before making my original post, I had clicked on "Steve Davis Cabinets" only to find that it...musar — 02:25 PM |
philco predicta
|
Welcome to the Phorum, cgl18! I am not your resource for television repair, but lots of friendly help is available here...GarySP — 02:12 PM |
Model 70 Cabinet Trim
|
Welcome to the Phorum, musar! You can send Steve Davis a private message (PM). The site is at the top of the Home page...GarySP — 02:09 PM |
Model 70 Cabinet Trim
|
How do I contact him? The only contact information for him I could find when searching online was a telephone number th...musar — 10:38 AM |
philco predicta
|
Hello, good afternoon, I would like to ask what the possible problem could be if I don't have an image on the screen. I ...cgl18 — 10:19 AM |
Philco model 38 code 121 not receiving signal.
|
So one last question before I finish this radio. Regarding the speaker and output transformer. I salvaged the original o...Stormlord5500 — 09:31 AM |
462ron
|
It’s on the bottom of the homepage of our Philcoradio.com homepage!
Ron462ron — 07:20 AM |
Who's Online
|
There are currently no members online. |
|

|