[49Stude63]

I looked it up and on page 2-30 6287-DU has two 0.15 uf caps installed as I described. The end that where the bakelite block mounts to the chassis is pin #1 and it will have 6 terminals 3 on one side and 3 on the opposite side. all 6 of these terminals mount to 3 brass eyelets in the middle of the block. Take both of your 0.15 caps and put one leg of each cap into the eyelet closest to pin #1 then take the other leg of cap 1 and put the second let though the middle eyelet and the 2nd leg of the 2nd cap and put it into the eyelet farthest from the #1 pin. Pin #1 is grounded so if you have connections to the 2 lugs farthest from pin #1 the circuit will see 0.15uf and if you have connections to the middle lugs it will also see 0.15uf and you can have connections to the 1st set of lugs from pin #1 and these connections will be to chassis ground. Situate the caps and solder the cap leads to the eyelets and clip off the excess leads.