1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco Mod. 144 help needed
KCMike
Phorum Expert
*****
Posts: 1,475
Threads: 69
Joined: Nov 2012
City: Kansas city, MO.
#12

06-04-2013, 02:27 PM
I retested all tubes in the philco 144. Found the 42 is bad and replaced. I powered back up with variac to 110v with a dim bulb tester and amp. meter. The amperage draw is reading right at .5 amps. I can get some low pitched squeel/static when touching the 75 grid cap or the lugs on the volume control. With volume 3/4 to all way up. I have a 12 guage copper wire from ant. to water pipe.
I really will appreciate any advice on how to proceed to trouble shoot from this point. I can post pics of before and after recap if needed. Thanks Mike
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Philco Mod. 144 help needed - by KCMike - 05-31-2013, 12:21 PM
RE: Philco Mod. 144 help needed - by morzh - 05-31-2013, 12:28 PM
RE: Philco Mod. 144 help needed - by KCMike - 05-31-2013, 01:06 PM
RE: Philco Mod. 144 help needed - by morzh - 05-31-2013, 01:41 PM
RE: Philco Mod. 144 help needed - by KCMike - 05-31-2013, 01:53 PM
RE: Philco Mod. 144 help needed - by morzh - 05-31-2013, 01:57 PM
RE: Philco Mod. 144 help needed - by KCMike - 05-31-2013, 06:40 PM
RE: Philco Mod. 144 help needed - by morzh - 05-31-2013, 08:01 PM
RE: Philco Mod. 144 help needed - by KCMike - 05-31-2013, 08:18 PM
RE: Philco Mod. 144 help needed - by morzh - 05-31-2013, 08:52 PM
RE: Philco Mod. 144 help needed - by KCMike - 05-31-2013, 09:17 PM
RE: Philco Mod. 144 help needed - by KCMike - 06-04-2013, 02:27 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM
Philco model 38 code 121 not receiving signal.
Good news everyone! I think I have found everything I need for rewinding the antenna coil primary. I found some pla...Stormlord5500 — 09:40 AM
Philco Battery-WWII vintage
My younger sister went to SUNY Plattsburg NY, (BS, MS, RN) in the late 1970sabout 10 min from the Northern NY / Canada b...MrFixr55 — 07:59 AM
Philco Battery-WWII vintage
Hello Bob, What Amazing find! Sincerely Richardradiorich — 10:19 PM
Testing a speaker and output transformer Trutone A2-G
Hi Murf, Do this: Monitor between ground and one plate of the rectifier while playing the radio.  Do the same with ...MrFixr55 — 09:51 PM
Philco Battery-WWII vintage
Mike; I take it that Soviet cars did not come equipped with block heaters, hence the hot oil change? Where I lived in...Arran — 08:42 PM
Philco 42-345 Restoration/Repair
The more the better. (Within reasonable limits.) 2-5 times more is no problem in this case.Vlad95 — 03:50 PM
Philco 42-345 Restoration/Repair
Thanks, RodB and Vlad95, I was mainly trying to figure out this capacitor to locate a replacement, Vlad thank you for...osanders0311 — 03:44 PM

[-]
Who's Online
There are currently 1460 online users. [Complete List]
» 1 Member(s) | 1459 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration