1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
philco model 47-1230 speaker plug connection ????
victor3d
Junior Member
**
Posts: 17
Threads: 3
Joined: Jun 2013
City: nyc
#7

06-11-2013, 10:00 AM
OK...now that everything is hooked up correctly and the AM is alligned, I need to recone my speaker as it is badly torn....(I pieced it together with speaker glue enough to be able to use it for the allignment). A member from my club informs me that the specs on this speaker part no. 36-1595 should read 5.1 ohms for the voice coil and 650 ohms for the field coil....my reading are 3.6 ohms and 647 ohms respectively........so the field coil seems to be pretty much right on but the voice coil is a bit low......As I am not well versed in such matters I am asking for opinions on this forum before I take the time and expense to re cone....thanks Yan, I would be interested to know what your speaker measures as I am thinking that sometimes the reported specs may not be accurate......
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
RE: philco model 47-1230 speaker plug connection ???? - by victor3d - 06-11-2013, 10:00 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM
Philco model 38 code 121 not receiving signal.
Good news everyone! I think I have found everything I need for rewinding the antenna coil primary. I found some pla...Stormlord5500 — 09:40 AM
Philco Battery-WWII vintage
My younger sister went to SUNY Plattsburg NY, (BS, MS, RN) in the late 1970sabout 10 min from the Northern NY / Canada b...MrFixr55 — 07:59 AM

[-]
Who's Online
There are currently 1744 online users. [Complete List]
» 4 Member(s) | 1740 Guest(s)
AvatarAvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration