1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Hello everyone, new to site.
plymouthrod
Junior Member
**
Posts: 4
Threads: 1
Joined: Jul 2013
City: Stone Mountain, Ga
#3

07-11-2013, 09:24 PM
Thank you for the welcome Terry!
I almost bought a 38-22CS but held out for the 38-7T. I like the cone-centric
tuning a lot. And also the shadow dial too.

Also I have several Philco cathedral radios, a 620 and a 38-9 table model. So I am sure I will need lots of info to get the necessary repairs done.

David
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Hello everyone, new to site. - by plymouthrod - 07-11-2013, 03:48 PM
RE: Hello everyone, new to site. - by 7estatdef - 07-11-2013, 08:46 PM
RE: Hello everyone, new to site. - by plymouthrod - 07-11-2013, 09:24 PM
RE: Hello everyone, new to site. - by klondike98 - 07-11-2013, 09:34 PM
RE: Hello everyone, new to site. - by Arran - 07-11-2013, 10:26 PM
RE: Hello everyone, new to site. - by plymouthrod - 07-12-2013, 08:03 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
PT 6 chassis screws size???
Hello bridKarl, that sounds right or maybe 8/32 . Sincerely Richardradiorich — 01:00 AM
PT 6 chassis screws size???
Have this done except for missing chassis screws. It looks like 1 inch 6/32 sheet metal screw may work but can anyone s...bridkarl — 10:32 PM
Philco model 38 code 121 not receiving signal.
Hello Stormlord, Well done on rewinding that coil it turned fairly good for your first one. Sincerely Richardradiorich — 09:12 PM
Philco model 38 code 121 not receiving signal.
Well here it is. It ain't pretty, but hopefully it'll work. I checked it with my DMM on continuity and it keeps and r...Stormlord5500 — 08:56 PM
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM

[-]
Who's Online
There are currently 677 online users. [Complete List]
» 1 Member(s) | 676 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration