Need help restoring my 40-180 - SUCCESS
Posts: 1,562
Threads: 56
Joined: Nov 2008
City: Sedona, AZ/Placentia/CA
Fossil, alignment can often help in a radio's reception but unless you have a signal generator, this is a little premature worry. Get the radio working first and see how it responds to signals in your area. I do like to do a "full" alignment but I have the equipment, often I can get the radio to work a little better if no one else has been in messing with the magic screwdriver. Removing and replacing wires may change alignment a little depending on how you route the wires. Don't worry about that part right now and replace the wires etc. keeping length a routing the same. Take pictures!
Some people with good ears can do alignment without a signal generator, I'm practically deaf.
Jerry
A friend in need is a pest! Bill Slee ca 1970.
(This post was last modified: 09-12-2013, 12:03 AM by jerryhawthorne.)
Messages In This Thread
RE: Need help restoring my 40-180 - by jerryhawthorne - 09-12-2013, 12:02 AM
Users browsing this thread: 1 Guest(s)
|
Recent Posts
|
Philco model 38 code 121 not receiving signal.
|
So one last question before I finish this radio. Regarding the speaker and output transformer. I salvaged the original o...Stormlord5500 — 09:31 AM |
462ron
|
It’s on the bottom of the homepage of our Philcoradio.com homepage!
Ron462ron — 07:20 AM |
Model 70 Cabinet Trim
|
Steve might have some trim left.
Not sure he is making anything.morzh — 06:12 AM |
Model 70 Cabinet Trim
|
Hello musar,
First all welcome to the forum and yes that is true that steve stopped making trim .
Sincerely Richar...radiorich — 12:13 AM |
Model 70 Cabinet Trim
|
I have recently come into possession of a Model 70. The trim around the base needs to be replaced. If this were years ...musar — 12:07 AM |
philcorepairbench.com - shadow-meter
|
Anyone know of a way to recover these files from the repair bench? Thanks.
fenbach — 11:16 PM |
Philco model 38 code 121 not receiving signal.
|
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM |
Philco model 38 code 121 not receiving signal.
|
A DMM is good enough.
One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM |
Testing a speaker and output transformer Trutone A2-G
|
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now.
Have better volu...murf — 03:43 PM |
Philco model 38 code 121 not receiving signal.
|
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM |
Who's Online
|
There are currently 353 online users. [Complete List] » 2 Member(s) | 351 Guest(s)
|
|
|

|