Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Picked this up today model 43
#7

2 have been bypassed. 1 orange drop has been added but other than that no work has been done to it.


[Image: http://i1365.photobucket.com/albums/r745...92b68d.jpg]

It has all the changes in the Riders manual, plus a 500 ohm resistor and trimmer on the cathode of the 1st detector not mentioned. Well there is mention of a half plate cap and the alignment for it, but it's not on the schematic or the resistor parts list.

The speaker cone is shot, but all the coils and IF's ring good and the tubes all check good as well.

Ron, the chassis is stamped G57776. I don't know if that helps date it in the run or not ??

John
Las Vegas, NV USA


Messages In This Thread
Picked this up today model 43 - by LASJayhawk - 12-21-2013, 10:23 PM
RE: Picked this up today model 43 - by sam - 12-21-2013, 11:36 PM
RE: Picked this up today model 43 - by Jamie - 12-22-2013, 03:23 PM
RE: Picked this up today model 43 - by TA Forbes - 12-22-2013, 09:59 PM
RE: Picked this up today model 43 - by LASJayhawk - 12-23-2013, 09:12 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
So one last question before I finish this radio. Regarding the speaker and output transformer. I salvaged the original o...Stormlord5500 — 09:31 AM
462ron
It’s on the bottom of the homepage of our Philcoradio.com homepage! Ron462ron — 07:20 AM
Model 70 Cabinet Trim
Steve might have some trim left. Not sure he is making anything.morzh — 06:12 AM
Model 70 Cabinet Trim
Hello musar, First all welcome to the forum and yes that is true that steve stopped making trim . Sincerely Richar...radiorich — 12:13 AM
Model 70 Cabinet Trim
I have recently come into possession of a Model 70.  The trim around the base needs to be replaced.  If this were years ...musar — 12:07 AM
philcorepairbench.com - shadow-meter
Anyone know of a way to recover these files from the repair bench? Thanks. fenbach — 11:16 PM
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM

[-]
Who's Online
There are currently no members online.

>