Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

46-1203 / Low Phono Volume Question
#5

Thanks for the input, folks!

The cartridge in the radio is a Shure W60B, it's been pretty difficult finding a 752-S3 needle for proper playback of the Crosby/Kern 78's I have, so for the moment it has a speed compromise needle (752-S2) - that wouldn't also be part of the problem would it? I've seen the cartridge-rebuild info floating around this forum, and might give it a shot soon. Worst case scenario I just order a new/old cartridge

As for the electronics - when I received the radio, it had a small bag of clipped paper-and-wax components, so I'm assuming someone had already done a little work on it before i received it, but I will double check this when I pull the electronics out to clean up and re-stain the case.

Is there a good write up somewhere on removing the electronics from this model without damaging anything? I'm most worried about the tuning apparatus getting messed up.


Messages In This Thread
46-1203 / Low Phono Volume Question - by sbish - 03-06-2014, 02:56 PM
RE: 46-1203 / Low Phono Volume Question - by sbish - 03-08-2014, 04:04 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
Thank you sir. Yes I feel good and also relieved because this one's been weighing on me a bit.Stormlord5500 — 11:18 AM
Philco model 38 code 121 not receiving signal.
It feels good don't it? Good luck on the rest.Paul Philco322 — 11:06 AM
Philco model 38 code 121 not receiving signal.
I've reinstalled the coil. Now IT'S ALIVE!!!!!! I fired up my TinySA on signal generator mode and set it to 1400Kc and ...Stormlord5500 — 11:01 AM
Philco model 38 code 121 not receiving signal.
Yes, Walmart, right up there with Fluke.RodB — 11:00 AM
PT 6 chassis screws size???
it certainly won't be metric! SAE threads were all that was known then. Take care, - GaryGarySP — 10:58 AM
Philco model 38 code 121 not receiving signal.
I think this thing is way more accurate than my Walmart DMM. :DStormlord5500 — 08:19 AM
Philco model 38 code 121 not receiving signal.
Thankyou for the kind words sir. I double checked it with my component tester and it read 2.7 ohms at .02mH.Stormlord5500 — 08:14 AM
PT 6 chassis screws size???
Hello bridKarl, that sounds right or maybe 8/32 . Sincerely Richardradiorich — 01:00 AM
PT 6 chassis screws size???
Have this done except for missing chassis screws. It looks like 1 inch 6/32 sheet metal screw may work but can anyone s...bridkarl — 10:32 PM
Philco model 38 code 121 not receiving signal.
Hello Stormlord, Well done on rewinding that coil it turned fairly good for your first one. Sincerely Richardradiorich — 09:12 PM

[-]
Who's Online
There are currently 853 online users. [Complete List]
» 1 Member(s) | 852 Guest(s)
Avatar

>