Posts: 1,531
Threads: 242
Joined: Sep 2012
City: West Bend, Wisconsin
 Fantastic!!! Way to go, Will. I felt bad that, with all of your patience and help, my set started cooperating and working, and you were still struggling with yours. It didn't seem fair.
It feels good to tame a wild beast like this, doesn't it?
I did re-stuff the tone control block on mine, per the schematic, but only after the set was back together in the cabinet did I discover it doesn't change the sound any in either position.  What value caps did you use in yours?
Greg V.
West Bend, WI
Member WARCI.org
Users browsing this thread: 2 Guest(s)
|
Recent Posts
|
PT 6 chassis screws size???
|
Hello bridKarl,
that sounds right or maybe 8/32 .
Sincerely Richardradiorich — 01:00 AM |
PT 6 chassis screws size???
|
Have this done except for missing chassis screws.
It looks like 1 inch 6/32 sheet metal screw may work but can anyone s...bridkarl — 10:32 PM |
Philco model 38 code 121 not receiving signal.
|
Hello Stormlord,
Well done on rewinding that coil it turned fairly good for your first one.
Sincerely Richardradiorich — 09:12 PM |
Philco model 38 code 121 not receiving signal.
|
Well here it is. It ain't pretty, but hopefully it'll work.
I checked it with my DMM on continuity and it keeps and r...Stormlord5500 — 08:56 PM |
Philco 42-345 Restoration/Repair
|
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM |
Philco 42-345 Restoration/Repair
|
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM |
Philco model 38 code 121 not receiving signal.
|
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM |
Testing a speaker and output transformer Trutone A2-G
|
The equivalent of one short turn is basically the same as that of a shorted load.
If it is the primary's turn, then the ...morzh — 03:53 PM |
Testing a speaker and output transformer Trutone A2-G
|
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM |
Philco model 38 code 121 not receiving signal.
|
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM |
Who's Online
|
There are currently 739 online users. [Complete List] » 1 Member(s) | 738 Guest(s)
|
|
|

|