Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Reprodet???
#6

Thanks guys,
Radio has been only brought up on variac, would never play without servicing.
Ron, The number from the earlier post was found on the bottom of chassis- probably that part number. The only other number I found was XX 16703.
[Image: http://i1079.photobucket.com/albums/w511...CF1327.jpg]
[Image: http://i1079.photobucket.com/albums/w511...CF1328.jpg]
[Image: http://i1079.photobucket.com/albums/w511...CF1329.jpg]
Thanks,
Joe


Messages In This Thread
Reprodet??? - by jph14 - 04-03-2014, 06:47 PM
RE: Reprodet??? - by Warren - 04-03-2014, 08:22 PM
RE: Reprodet??? - by skyscraper - 04-03-2014, 09:13 PM
RE: Reprodet??? - by Warren - 04-03-2014, 11:41 PM
RE: Reprodet??? - by Ron Ramirez - 04-04-2014, 05:38 AM
RE: Reprodet??? - by jph14 - 04-04-2014, 09:42 AM
RE: Reprodet??? - by Don Lind - 04-04-2014, 07:03 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2098 online users. [Complete List]
» 3 Member(s) | 2095 Guest(s)
AvatarAvatarAvatar

>