Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

U.S.Radio & Television Corp- Model 80
#3

Hello Fellow Texan, I was very glad to see your response to my big old paperweight. I had a felling that another company was involved and I'm sure glad you knew who it was. The radio had nothing to identify the company except the escutcheon which was for a Majestic but is incorrect for the dial. The cabinet also looks like a late Philco 65. The interior of the cabinet had been modified for this chassis with two additional pieces of 2X4 and two new holes drilled.The tube lineup you listed is correct for my chassis but my Vol I of the JF Rider does not show the Majestic 70 having nine tubes nor could I find the same tube lineup in Nostalgiaair. Do you have another source that does show the Model 80 with nine tubes? Thanks again for all of your help. I'm sure I will have more questions before this old puppy is put to bed.


Messages In This Thread
U.S.Radio & Television Corp- Model 80 - by Dave D - 09-06-2008, 12:38 PM
Re: U.S.Radio & Television Corp- Model 80 - by Dave D - 09-11-2008, 01:09 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Electrolytic restuffing/internals
Thanks. I think I try to cut this as suggested. I don’t have a lathe, but I do have a tap and die set. I am going to see...bridkarl — 04:46 PM
Another amp build - here I go again!
Hey all! Well, I guess that with what I learned from my last build, it's time to move up the ladder another rung and tak...TV MAN — 04:38 PM
Electrolytic restuffing/internals
There are various ways to handle this, one is to cut near just above that rolled in area is near the bottom, using the r...Arran — 04:36 PM
philco predicta
If you have a television signal generator (a must-have for TV repair) and an oscilloscope (the same), then this problem ...RadioSvit — 04:23 PM
HiFi (Chifi) tube amp build - but my own design.
Thanks Rod for the offer but I don't think those would work. There's some differences in the sizing and mounting holes b...TV MAN — 03:13 PM
philco predicta
Bob Anderson (Bandersontv) on Youtube would be the go-to guy on these. Lots of good videos. I don't know what model you ...TV MAN — 03:02 PM
Electrolytic restuffing/internals
I have an issue on a non-Philco radio which I expect to run into on a whole set of Philcos and others. I have an 8mf ...bridkarl — 01:17 PM
Philco model 38 code 121 not receiving signal.
Thank you sir. I thought about it and decided to put it up in the arch support. I was looking at the chassis and didn't ...Stormlord5500 — 06:24 AM
Philco model 38 code 121 not receiving signal.
Congrats on your success Stormlord. My rough guess is that since both the 15 and the 1A6 are supposed to be shielded, I...MrFixr55 — 10:04 PM
The list of my radio & TV collection!
A little light Saturday positive about our hobby in our feed... My new every Saturday video about antique radio equipme...RadioSvit — 02:12 PM

[-]
Who's Online
There are currently 657 online users. [Complete List]
» 2 Member(s) | 655 Guest(s)
AvatarAvatar

>