Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 42-380X Reception problems
#16

Hi

Did some adjusting of the compensator's, 34, 31, 1nd 29A & B by ear and had some marginal response on the AM band. The middle, or Police band, seems to be OK, but I have to turn the volume way up to hear the stations. The upper, or SW band, is the one with the worst response. What stations that can be tuned in are garbled as if there is some back ground interference. The voices on this band are distorted and unclear I replaced the two weak 41 tubes and all the capacitors except # 24 which is near impossible to reach it is so buried. I hooked the radio to it's antenna in the case and did my adjusting using it but the SW band as mentioned is still garbled. Any thoughts on why the SW bands reception is so noisy or garbled? Further, I wish I knew how to use he signal generator I have, it's a nice one but I don't know how to hook it up to tune the radio. Any one out there real good at using signal generators, I sure would like to use the one I have.

God bless,

Dave B

Joh 3:7 Marvel not that I said unto thee, Ye must be born again


Messages In This Thread
Philco 42-380X Reception problems - by David B - 09-14-2008, 09:51 AM
Re: Philco 42-380X Reception problems - by David B - 09-26-2008, 11:57 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Restoration of the Canadian General Electric A-87
Thanks for your help Michael. In fact, this video is only an intermediate result. Later I had to apply another tinting l...RadioSvit — 09:01 AM
Restoration of the Canadian General Electric A-87
Great job on the cabinet. PS. In the US notation, "kenotron" refers to specific type of tubes; we call re...morzh — 08:24 AM
Part numbers to model cross
This document has at least some tables of models and parts used. Example: Choke 32-7572, used in 604 radio. Search f...morzh — 08:19 AM
Restoration of the Canadian General Electric A-87
I also checked all the radio tubes on my Hickok 530 tube tester. The 5Z3 kenotron turned out to be faulty, all the other...RadioSvit — 08:02 AM
Restoration of the Canadian General Electric A-87
Well... While the varnish is drying up, I started repairing the chassis... Of course I started by replacing the pa...RadioSvit — 07:12 AM
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM

[-]
Who's Online
There are currently 1103 online users. [Complete List]
» 1 Member(s) | 1102 Guest(s)
Avatar

>