Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 42-1010 Dial Stringing
#9

All right. I went out to the garage, and looked over my 42-1010 chassis carefully. Then I came back inside and looked through the Philco 1942 RMS Year Book and found that, while the dial cord stringing diagram is not given for Models 42-1010 and 42-1011, it IS given for Models 42-1012 and 42-1013.

Good news...the dial cord diagram for the 1012 & 1013 is the same as what you need for your 1010.

Here it is...

[Image: http://i326.photobucket.com/albums/k420/...alcord.jpg]

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
Philco 42-1010 Dial Stringing - by Jon Scaptura - 12-12-2005, 07:38 PM
[No subject] - by Terry Judkins - 12-13-2005, 12:24 AM
[No subject] - by Chuck Schwark - 12-13-2005, 09:55 AM
[No subject] - by Jon Scaptura - 12-13-2005, 10:23 AM
[No subject] - by Chuck Schwark - 12-13-2005, 11:58 AM
[No subject] - by Ron Ramirez - 12-13-2005, 01:30 PM
[No subject] - by Jon Scaptura - 12-13-2005, 04:45 PM
[No subject] - by Ron Ramirez - 12-13-2005, 05:58 PM
[No subject] - by Ron Ramirez - 12-13-2005, 06:53 PM
[No subject] - by Chuck Schwark - 12-13-2005, 08:16 PM
Thanks - by Jon Scaptura - 12-13-2005, 11:36 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM
Philco model 38 code 121 not receiving signal.
Good news everyone! I think I have found everything I need for rewinding the antenna coil primary. I found some pla...Stormlord5500 — 09:40 AM
Philco Battery-WWII vintage
My younger sister went to SUNY Plattsburg NY, (BS, MS, RN) in the late 1970sabout 10 min from the Northern NY / Canada b...MrFixr55 — 07:59 AM

[-]
Who's Online
There are currently 1753 online users. [Complete List]
» 3 Member(s) | 1750 Guest(s)
AvatarAvatarAvatar

>