Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

41-81T my next project
#1

My next Philco project is going to be a 41-81T, portable, battery powered radio. I picked it up very reasonably on ePay, which was a pleasant surprise. I was expecting to be outbid. When I received it and opened it, I found that the original Philco battery was still inside ! Even more amazing is that the battery has not leaked, and so I have one with good outside graphics, which I have scanned, so I can make a cover for the replacement battery unit I will make for it. Here are some pictures of it on my work bench.
[Image: https://33.media.tumblr.com/c5503dc8bd4f...1_1280.jpg]
[Image: https://33.media.tumblr.com/0750bac62203...1_1280.jpg]
[Image: https://33.media.tumblr.com/da165c1935b1...2_1280.jpg]
Should keep me amused for some weeks. Icon_e_biggrin


Messages In This Thread
41-81T my next project - by mikethedruid - 10-11-2014, 03:27 PM
RE: 41-81T my next project - by klondike98 - 10-11-2014, 09:21 PM
RE: 41-81T my next project - by Ron Ramirez - 10-11-2014, 09:46 PM
RE: 41-81T my next project - by mikethedruid - 10-11-2014, 11:36 PM
RE: 41-81T my next project - by morzh - 10-12-2014, 02:47 PM
RE: 41-81T my next project - by mikethedruid - 12-18-2014, 03:18 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2206 online users. [Complete List]
» 4 Member(s) | 2202 Guest(s)
AvatarAvatarAvatarAvatar

>