Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Rebuilding a Rittenhouse RCM-3
#9

Bob - Thanks! Icon_biggrin

(12-06-2014, 10:59 PM)mafiamen2 Wrote:  HEY RON
what`s the receivers look like? can you play music in all rooms
noticed it has a jack next to volume. small for phono input

Do you mean the remotes? I'll take a picture of one, and post it, tomorrow. Yes, we can play music throughout the house, which is why I really wanted to get the RCM-3 master control unit going again. The RCM-3 is in the dining room. There is one remote in the living room, and another in the basement. The jack next to the intercom volume control is indeed an RCA jack for an extra phono input. It also has two jacks in the basement wired up to the master control unit; these are for phono or auxiliary input. The jacks in the basement look like the old-time TV antenna sockets I used to see in electronic catalogs when I was young, but they are labeled "Rittenhouse".

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
Rebuilding a Rittenhouse RCM-3 - by Ron Ramirez - 12-06-2014, 09:45 PM
RE: Rebuilding a Rittenhouse RCM-3 - by sam - 12-06-2014, 10:59 PM
RE: Rebuilding a Rittenhouse RCM-3 - by Ron Ramirez - 12-06-2014, 11:30 PM
RE: Rebuilding a Rittenhouse RCM-3 - by w4rtc - 12-07-2014, 12:22 PM
RE: Rebuilding a Rittenhouse RCM-3 - by morzh - 12-07-2014, 12:35 PM
RE: Rebuilding a Rittenhouse RCM-3 - by Arran - 12-09-2014, 02:04 AM
RE: Rebuilding a Rittenhouse RCM-3 - by Arran - 12-10-2014, 03:18 AM
RE: Rebuilding a Rittenhouse RCM-3 - by KCMike - 12-07-2014, 05:11 PM
RE: Rebuilding a Rittenhouse RCM-3 - by sam - 12-07-2014, 08:12 PM
RE: Rebuilding a Rittenhouse RCM-3 - by Arran - 12-10-2014, 02:00 AM
RE: Rebuilding a Rittenhouse RCM-3 - by mtk212 - 09-20-2024, 06:28 PM



Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently no members online.

>