Here we go with a Brand Z 9-S-262
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand
State, Province, Country: Indiana
I just ordered the resistors needed to replace the Candohm, along with a few 25 pF and 500 pF mica caps. I'll also have to find a 6U5 or 6E5. This chassis has a 6T5 in it...but it is a dead tube, open filament.
While I am waiting on these parts, I should draw my own diagram so I will know how to hook up all of the wires to the volume control, and where the mica caps need to be attached.
I've junked enough Philcos that I have some very long terminal strips. I'll use one in this set for attaching the Candohm replacement resistors.
It was slow getting started, but I think I'm getting into a good groove here. When you're used to working on just Philcos, working on something from another manufacturer is a bit confusing.
--
Ron Ramirez
Ferdinand IN
Messages In This Thread
RE: Here we go with a Brand Z 9-S-262 - by Ron Ramirez - 12-24-2014, 11:08 PM
Users browsing this thread: 1 Guest(s)
|
Recent Posts
|
Philco model 38 code 121 not receiving signal.
|
I think this thing is way more accurate than my Walmart DMM. :DStormlord5500 — 08:19 AM |
Philco model 38 code 121 not receiving signal.
|
Thankyou for the kind words sir.
I double checked it with my component tester and it read 2.7 ohms at .02mH.Stormlord5500 — 08:14 AM |
PT 6 chassis screws size???
|
Hello bridKarl,
that sounds right or maybe 8/32 .
Sincerely Richardradiorich — 01:00 AM |
PT 6 chassis screws size???
|
Have this done except for missing chassis screws.
It looks like 1 inch 6/32 sheet metal screw may work but can anyone s...bridkarl — 10:32 PM |
Philco model 38 code 121 not receiving signal.
|
Hello Stormlord,
Well done on rewinding that coil it turned fairly good for your first one.
Sincerely Richardradiorich — 09:12 PM |
Philco model 38 code 121 not receiving signal.
|
Well here it is. It ain't pretty, but hopefully it'll work.
I checked it with my DMM on continuity and it keeps and r...Stormlord5500 — 08:56 PM |
Philco 42-345 Restoration/Repair
|
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM |
Philco 42-345 Restoration/Repair
|
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM |
Philco model 38 code 121 not receiving signal.
|
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM |
Testing a speaker and output transformer Trutone A2-G
|
The equivalent of one short turn is basically the same as that of a shorted load.
If it is the primary's turn, then the ...morzh — 03:53 PM |
Who's Online
|
There are currently 741 online users. [Complete List] » 1 Member(s) | 740 Guest(s)
|
|
|

|