Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

How I spent my Sunday afternoon...
#1

....restoring this 1942 Model 42-321T!

OK, two in one weekend...that's a record for me. But this one required very little cosmetic restoration; the finish is all original. I just had to touch up some of the dark trim. Much like the 1948 model I did yesterday, the electronic restoration only required a recap...along with some crumbling wire replacement. Now I didn't replace all of the rubber wire, only those that were either badly cracked or just starting to crack. The others were examined and if they were in no danger of touching anything else and were still somewhat pliable, without cracking when moved, I let them be.

   
   
   
   
   

Greg V.
West Bend, WI
Member WARCI.org


Messages In This Thread
How I spent my Sunday afternoon... - by NostalgiaRadioTime - 03-08-2015, 08:38 PM
RE: How I spent my Sunday afternoon... - by sam - 03-08-2015, 10:04 PM
RE: How I spent my Sunday afternoon... - by Jayce - 03-10-2015, 10:17 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2225 online users. [Complete List]
» 4 Member(s) | 2221 Guest(s)
AvatarAvatarAvatarAvatar

>