Car Radio Push Button Issue

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Car Radio Push Button Issue

VntgRads
Member

Posts: 246
Threads: 27
Joined: Aug 2013
City: Petaluma, CA

03-15-2015, 01:44 AM

Thanks, Terry, for the info. I do stay away from the clutches when using silicone. It is used for the metal on metal areas. Sometimes the clutch disc is frozen and it takes some gentle persuasion to separate the rubber/metal discs. The push buttons will not operate in this case as the clutch will not disengage. On the other hand, sometimes the discs slip too much which results in loss of manual tuning. In this case, a little piece of sandpaper between the discs can be helpful.

Craig R.

Find

« Next Oldest | Next Newest »

Thread Closed

Messages In This Thread

Car Radio Push Button Issue - by VntgRads - 03-12-2015, 12:33 PM

RE: Car Radio Push Button Issue - by Radioroslyn - 03-13-2015, 07:27 AM

RE: Car Radio Push Button Issue - by VntgRads - 03-15-2015, 01:44 AM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

Who's Online

There are currently 2214 online users. [Complete List]
» 2 Member(s) | 2212 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me