[Eric]

Here is where I'm at this morning The 60cyc goes away as the voltage goes above 4vdc . The power supply seems to put out the proper voltages with out any problems.
I'm a little puzzled with the voltage readings here they are going from the ant section 
     Heater        Plate     Grid
1     5vdc         87           0        01A
2     5vdc        116         -22     71A
3     5vdc         87           0        01A
4     5vdc         82           0        01A
5     5vdc         87           0        01A
6     5vdc         22           .5       01A
I then hooked up my signal generator to the ant terminal through a .01 cap and set it to 680 (a strong station in this area). Then played with the 2 tuner wheels until I found a static pop then hooked up my ant wire and played with the volume control and the tuner wheels at that point and the station came in, not real loud but you could listen. Not sure what to expect but this might be as good as it gets?