Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 1 Vote(s) - 2 Average
  • 1
  • 2
  • 3
  • 4
  • 5

39-30 Refurb
#10

I finally got around to hooking up a PM speaker. I lifted the 2 voice coil wires off the original speaker and jumpered them to a PM speaker I picked up in my last DK order (easier than digging one out of my parents basement). This is the speaker, if it matters: http://www.digikey.com/product-detail/en...-ND/304447

Anyway, still sounds distorted on the mid and full bass settings. Not sure if that speaker is just too small to handle it, or if that means I do have an issue else where.


Messages In This Thread
39-30 Refurb - by Nick3092 - 05-13-2015, 10:32 PM
RE: 39-30 Refurb - by Radioroslyn - 05-14-2015, 06:25 AM
RE: 39-30 Refurb - by Nick3092 - 05-14-2015, 09:17 AM
RE: 39-30 Refurb - by morzh - 05-14-2015, 09:53 AM
RE: 39-30 Refurb - by Nick3092 - 05-14-2015, 10:56 AM
RE: 39-30 Refurb - by Nick3092 - 05-14-2015, 06:58 PM
RE: 39-30 Refurb - by Nick3092 - 05-14-2015, 10:58 PM
RE: 39-30 Refurb - by Nick3092 - 05-15-2015, 08:24 AM
RE: 39-30 Refurb - by morzh - 05-15-2015, 01:56 PM
RE: 39-30 Refurb - by Nick3092 - 05-24-2015, 09:33 PM
RE: 39-30 Refurb - by Nick3092 - 07-30-2015, 07:31 PM
RE: 39-30 Refurb - by Radioroslyn - 07-30-2015, 07:52 PM
RE: 39-30 Refurb - by Warren - 07-30-2015, 08:37 PM
RE: 39-30 Refurb - by Nick3092 - 07-31-2015, 08:19 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2215 online users. [Complete List]
» 1 Member(s) | 2214 Guest(s)
Avatar

>