Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Model 20 1930 Lowboy
#11

SWEET RADIO !!! I don't think that was any standard antenna, but an early add on to eliminate the need for an outdoor antenna. I was told about trying this by an elderly friend when I was a kid, and have used very similar antennas on consoles myself with very good results. It is definitely something I would keep, although I might rebuild it with new cloth covered wire. It will be quite directional however, so you will find stations toward the front and back direction of the receiver will be stronger than those coming from either side.


Messages In This Thread
Philco Model 20 1930 Lowboy - by Crist Rigotti - 05-27-2015, 10:58 PM
RE: Philco Model 20 1930 Lowboy - by morzh - 05-27-2015, 11:13 PM
RE: Philco Model 20 1930 Lowboy - by sam - 05-28-2015, 02:46 AM
RE: Philco Model 20 1930 Lowboy - by GarySP - 05-28-2015, 08:25 AM
RE: Philco Model 20 1930 Lowboy - by morzh - 05-28-2015, 11:03 AM
RE: Philco Model 20 1930 Lowboy - by PhilcoJohn - 05-29-2015, 06:59 AM
RE: Philco Model 20 1930 Lowboy - by Art Hoch - 05-29-2015, 11:54 AM
RE: Philco Model 20 1930 Lowboy - by mikethedruid - 05-30-2015, 07:01 PM
RE: Philco Model 20 1930 Lowboy - by morzh - 05-31-2015, 11:07 AM
RE: Philco Model 20 1930 Lowboy - by GarySP - 05-31-2015, 04:48 PM
RE: Philco Model 20 1930 Lowboy - by morzh - 05-31-2015, 04:53 PM
RE: Philco Model 20 1930 Lowboy - by GarySP - 05-31-2015, 09:26 PM
RE: Philco Model 20 1930 Lowboy - by GarySP - 05-31-2015, 09:35 PM
RE: Philco Model 20 1930 Lowboy - by morzh - 05-31-2015, 11:12 PM
RE: Philco Model 20 1930 Lowboy - by Fred Taylor - 06-01-2015, 08:01 AM
RE: Philco Model 20 1930 Lowboy - by morzh - 06-01-2015, 10:13 AM
RE: Philco Model 20 1930 Lowboy - by GarySP - 06-07-2015, 06:32 PM



Users browsing this thread:
[-]
Recent Posts
Restoration of the Canadian General Electric A-87
Well... The console body has been restored, while the varnish dries reliably I started repairing the chassis.. Of ...RadioSvit — 07:12 AM
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum, Martin! Open a new thread in Philco Electronic Restoration when you begin working on your 38-7. ...GarySP — 08:28 PM

[-]
Who's Online
There are currently 985 online users. [Complete List]
» 1 Member(s) | 984 Guest(s)
Avatar

>