Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5

What's it worth?
#14

Well done!  Icon_thumbup Icon_thumbup

What other radios did you make off with? 

If you check the prices of UV-199 tubes it will make you glad that they are all there. FYI the filaments on the UV-199 are diagonal to each other, not next to each other like the UX-199, just in case you want to test or even rejeuvenate them. 


Messages In This Thread
What's it worth? - by doc612 - 06-04-2015, 11:02 PM
RE: What's it worth? - by Phlogiston - 06-05-2015, 01:00 AM
RE: What's it worth? - by Arran - 06-05-2015, 01:44 AM
RE: What's it worth? - by Ron Ramirez - 06-05-2015, 05:53 AM
RE: What's it worth? - by Phlogiston - 06-05-2015, 11:02 AM
RE: What's it worth? - by Ron Ramirez - 06-05-2015, 12:52 PM
RE: What's it worth? - by doc612 - 06-05-2015, 06:52 AM
RE: What's it worth? - by morzh - 06-05-2015, 09:48 AM
RE: What's it worth? - by doc612 - 06-05-2015, 11:08 AM
RE: What's it worth? - by morzh - 06-05-2015, 11:20 AM
RE: What's it worth? - by Phlogiston - 06-05-2015, 01:37 PM
RE: What's it worth? - by TA Forbes - 06-05-2015, 01:41 PM
RE: What's it worth? - by doc612 - 06-05-2015, 10:25 PM
RE: What's it worth? - by TA Forbes - 06-05-2015, 10:38 PM
RE: What's it worth? - by Radioroslyn - 06-05-2015, 11:05 PM
RE: What's it worth? - by doc612 - 06-05-2015, 11:25 PM
RE: What's it worth? - by Ron Ramirez - 06-05-2015, 11:39 PM
RE: What's it worth? - by Arran - 06-06-2015, 12:46 AM
RE: What's it worth? - by doc612 - 06-06-2015, 09:38 PM
RE: What's it worth? - by doc612 - 06-06-2015, 09:33 PM
RE: What's it worth? - by Joe Rossi - 06-06-2015, 11:54 AM
RE: What's it worth? - by doc612 - 06-06-2015, 10:05 PM
RE: What's it worth? - by morzh - 06-06-2015, 10:14 PM
RE: What's it worth? - by doc612 - 06-06-2015, 10:26 PM
RE: What's it worth? - by Ron Ramirez - 06-06-2015, 11:27 PM
RE: What's it worth? - by Ron Ramirez - 06-06-2015, 11:28 PM
RE: What's it worth? - by doc612 - 06-08-2015, 05:28 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2230 online users. [Complete List]
» 4 Member(s) | 2226 Guest(s)
AvatarAvatarAvatarAvatar

>