Philco 70A

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 70A

plymouthrod
Junior Member

Posts: 4
Threads: 1
Joined: Jul 2013
City: Stone Mountain, Ga

#17

06-19-2015, 02:25 PM

Did anyone else notice this is a 25-40 hz chassis? It has the over-sized transformer. I recently picked up a 1st (early) run model 90 chassis from a low boy and it has the same 'white' decal instead of the 'gold' decal on the end of the tube shield.

Does anyone know if these 25-40 hz chassis sold here in the US are early chassis? The Canadian versions always seem to have the metal tag instead of the gold or white decals,

David

Find

« Next Oldest | Next Newest »

Thread Closed

Messages In This Thread

Philco 70A - by Crist Rigotti - 06-17-2015, 11:24 PM

RE: Philco 70A - by Phlogiston - 06-18-2015, 12:25 AM

RE: Philco 70A - by morzh - 06-18-2015, 09:41 AM

RE: Philco 70A - by Crist Rigotti - 06-18-2015, 09:47 AM

RE: Philco 70A - by Phlogiston - 06-18-2015, 10:38 AM

RE: Philco 70A - by Crist Rigotti - 06-18-2015, 10:41 AM

RE: Philco 70A - by Steve Davis - 06-18-2015, 12:25 PM

RE: Philco 70A - by Steve Davis - 06-18-2015, 12:31 PM

RE: Philco 70A - by GarySP - 06-18-2015, 12:52 PM

RE: Philco 70A - by TA Forbes - 06-18-2015, 01:03 PM

RE: Philco 70A - by Crist Rigotti - 06-18-2015, 02:34 PM

RE: Philco 70A - by Ron Ramirez - 06-18-2015, 05:53 PM

RE: Philco 70A - by Crist Rigotti - 06-18-2015, 08:25 PM

RE: Philco 70A - by Ron Ramirez - 06-18-2015, 08:51 PM

RE: Philco 70A - by morzh - 06-18-2015, 08:57 PM

RE: Philco 70A - by Crist Rigotti - 06-19-2015, 02:03 PM

RE: Philco 70A - by plymouthrod - 06-19-2015, 02:25 PM

RE: Philco 70A - by Crist Rigotti - 06-19-2015, 04:16 PM

RE: Philco 70A - by Ron Ramirez - 06-19-2015, 05:38 PM

RE: Philco 70A - by KCMike - 06-19-2015, 07:53 PM

RE: Philco 70A - by Crist Rigotti - 06-19-2015, 09:47 PM

RE: Philco 70A - by Ron Ramirez - 06-19-2015, 10:26 PM

RE: Philco 70A - by Arran - 06-19-2015, 10:36 PM

RE: Philco 70A - by Crist Rigotti - 06-19-2015, 10:41 PM

RE: Philco 70A - by Crist Rigotti - 06-19-2015, 11:21 PM

RE: Philco 70A - by KCMike - 06-20-2015, 01:51 PM

RE: Philco 70A - by Crist Rigotti - 06-20-2015, 07:51 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

Who's Online

There are currently 2279 online users. [Complete List]
» 4 Member(s) | 2275 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me