Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Scored a 41-280x this morning!
#19

(06-16-2015, 08:58 AM)GarySP Wrote:  After taking a closer look it appears the cabinet has been at least partially refinished in the past.  I repaired the small missing piece of veneer on the side.  Have to decide if I'm going to do a total refinish, or just spruce it up.  It's presentable as it sits, but not quite original in finish.  Thankfully, I'm not an anal purist when it comes right down to it.  Functional and pleasing to the eye works for me.  Take care, Gary

Be aware the two vertical pieces flanking the grill bars are photo-finish!! Icon_lol


Messages In This Thread
Scored a 41-280x this morning! - by GarySP - 06-13-2015, 05:11 PM
RE: Scored a 41-280x this morning! - by morzh - 06-13-2015, 06:56 PM
RE: Scored a 41-280x this morning! - by TA Forbes - 06-14-2015, 09:48 PM
RE: Scored a 41-280x this morning! - by GarySP - 06-14-2015, 10:16 PM
RE: Scored a 41-280x this morning! - by Arran - 06-15-2015, 01:02 AM
RE: Scored a 41-280x this morning! - by GarySP - 06-16-2015, 08:58 AM
RE: Scored a 41-280x this morning! - by Art Hoch - 06-19-2015, 09:49 PM
RE: Scored a 41-280x this morning! - by GarySP - 06-17-2015, 11:40 AM
RE: Scored a 41-280x this morning! - by morzh - 06-17-2015, 12:15 PM
RE: Scored a 41-280x this morning! - by GarySP - 06-18-2015, 01:11 PM
RE: Scored a 41-280x this morning! - by morzh - 06-18-2015, 06:24 PM
RE: Scored a 41-280x this morning! - by morzh - 06-18-2015, 08:53 PM
RE: Scored a 41-280x this morning! - by morzh - 06-19-2015, 10:42 AM
RE: Scored a 41-280x this morning! - by GarySP - 06-18-2015, 09:25 PM
RE: Scored a 41-280x this morning! - by Arran - 06-19-2015, 04:27 AM
RE: Scored a 41-280x this morning! - by GarySP - 06-20-2015, 04:17 PM
RE: Scored a 41-280x this morning! - by GarySP - 06-20-2015, 07:26 PM
RE: Scored a 41-280x this morning! - by Art Hoch - 06-20-2015, 09:30 PM



Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2266 online users. [Complete List]
» 4 Member(s) | 2262 Guest(s)
AvatarAvatarAvatarAvatar

>