Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

VICTORY! 41-290
#1

Thanks to all who helped me with this. The 41-290 works! In fact, it is quite a remarkable player with a whole lot of audio power that the speaker can't take. Great sensitivity and selectivity. I am a amazed how well these old radios play. Makes me think I should go back and recap everything in my 41-280. I sent it to a guy to just get it working and he did. He didn't repcap the whole thing though and kept the ones that were ok just to get it to play. If I go back into it and replace all the old cpaps and elec caps, do you think it will play better?

Again, thanks for everyone's assistance.
SF/MG
#2

Congratulations on a job well done! Icon_smile

Regarding your 41-280 - It will definitely benefit from having all of its paper and electrolytic capacitors replaced, as well as any off-tolerance resistors. Your 41-280 will thank you for it; yes, it will certainly play better and keep playing well longer. In fact it should work just as well as your 41-290 now does, as the two chassis are nearly identical (the 290 has two extra tubes, but the circuitry is nearly the same).

--
Ron Ramirez
Ferdinand IN




Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2152 online users. [Complete List]
» 1 Member(s) | 2151 Guest(s)
Avatar

>