Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 2 Vote(s) - 3.5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Ron's 2016 Cabinet Work Part I: Bozak E-300

 Thanks Ron.
 Being my first attempt at a large transistorized stereo I lean toward it being my error somewhere that caused the condition. The one thing I hope points to something simple is after the pop when first turned on it plays just fine with no noise and good selectivity and sensitivity.

(09-05-2016, 01:45 PM)KCMike Wrote:  ...I hooked a Lafayette mpx to it and the sound was , well weird. You could hear the music but it sounded like two different stations playing at once and the words to the songs sounded like they were in a echo chamber.

It could be that your left and right channels were out of phase with one another...or else there is a problem with the Lafayette MPX decoder. Most likely the former.

Quote:Been looking for a fisher tube amp and MPX. Wow, they are sure proud of them on ebay.

You can say that again! I bought my Fisher 400 at Kutztown back in May for $275. On the auction site they usually ask double or more. And you can't find a 500 or 800 there for less than $1000. Icon_eek

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
Hello Stormlord, Well done on rewinding that coil it turned fairly good for your first one. Sincerely Richardradiorich — 09:12 PM
Philco model 38 code 121 not receiving signal.
Well here it is. It ain't pretty, but hopefully it'll work. I checked it with my DMM on continuity and it keeps and r...Stormlord5500 — 08:56 PM
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM

[-]
Who's Online
There are currently 472 online users. [Complete List]
» 1 Member(s) | 471 Guest(s)
Avatar

>