Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

So! Am I a big dumby?
#1

I should have known better. Icon_rolleyes I am looking to get a 37-610T bullet radio, and bought a servive manual ahead of the radio. Upon looking closer, I see the manual is to a 37-610 not a 37-610T. Icon_redface So are these the same chassis or do I get the big DAH! award? Icon_lol

tractorforum.com *** I reserve the right to be wrong
#2

Don't worry, it is the same...that is, unless you have a Service Bulletin for a 37-610 Code 121 or 122, and end up owning a 37-610 Code 125 or 126.

The main difference is that the RF units are different. Also, if you want a table model it will be Code 122 or 126 (the rectifier tube is behind the power transformer, not mounted on top of it as in Codes 121 or 125).

--
Ron Ramirez
Ferdinand IN
#3

Thanks Ron. I thought that might be the case but wasn't sure. It only cost me a few bucks, and it is an original copy. Now I just gots to locate a radio. Icon_biggrin

tractorforum.com *** I reserve the right to be wrong




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
philco predicta
Hi CGL18, First off, welcome to the Philco Phorum. I have not worked on a TV for a while but here are some givens: ...MrFixr55 — 08:22 AM
Another amp build - here I go again!
Sweet! I actually have a Dynaco Mark 4 that I had been running with 6L6s with no mods. Seemed to my 14-year-old head a...MrFixr55 — 12:57 AM
PT-6 finished!!
Hi Gang, Tube heaters are not "Ohmic" devices (that maintain specified resistance over wide temperature, c...MrFixr55 — 12:03 AM
Electrolytic restuffing/internals
Look here: Philco-F676-124 Vlad95 — 08:02 PM
PT-6 finished!!
Well the 35Z3 doesn't have a tap on the tube heater for a pilot light, so in this set they have the dial lamp paralleled...Arran — 06:21 PM
Electrolytic restuffing/internals
Thanks. I think I try to cut this as suggested. I don’t have a lathe, but I do have a tap and die set. I am going to see...bridkarl — 04:46 PM
Another amp build - here I go again!
Hey all! Well, I guess that with what I learned from my last build, it's time to move up the ladder another rung and tak...TV MAN — 04:38 PM
Electrolytic restuffing/internals
There are various ways to handle this, one is to cut near just above that rolled in area is near the bottom, using the r...Arran — 04:36 PM
philco predicta
If you have a television signal generator (a must-have for TV repair) and an oscilloscope (the same), then this problem ...RadioSvit — 04:23 PM
HiFi (Chifi) tube amp build - but my own design.
Thanks Rod for the offer but I don't think those would work. There's some differences in the sizing and mounting holes b...TV MAN — 03:13 PM

[-]
Who's Online
There are currently no members online.

>