Posts: 6
Threads: 3
Joined: Jul 2017
City: Pawnee,IL
I am re-capping this 42-360. I found the Primary open on the 3rd. IF can.(32-3640) Red and white wires should be 14 ohms.
What can I replace this with? Also after opening up the can to replace the wires, there are no 100uuf caps inside the can.The schematic shows two of these in the can.
Posts: 7,323
Threads: 270
Joined: Dec 2009
City: Roslyn Pa
Got two answers. One connect a rf choke from the red to white wires then a small mica from the white to green wires. Or find a 455kc if output can and replace it or just the open winding.
http://philcoradio.com/phorum/showthread.php?tid=15651
Start reading at post 15.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got it!
Terry
(This post was last modified: 07-24-2017, 05:26 PM by
Radioroslyn.)
Posts: 5,584
Threads: 291
Joined: Nov 2012
City: Wilsonville
State, Province, Country: OR
Hope that thread helps! Terry talked me through it.
Posts: 3
Threads: 1
Joined: Sep 2016
City: springfield,il.
Radioengineer this is Gizmo
I have a Philco 42-360 and all the electronics are working. My problem is i need a dial string diagram? The good news is i live in Springfield,Il. not far from Pawnee.
Perhaps we could get together to our mutual benefit.
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
