Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Broadcast Bands?
#1

Does anyone broadcast anything anymore on the short wave, long wave or police bands?
#2

Broadcast band is what is commonly called "AM radio" Yes, there are many stations on that band. It runs from 550 KC to 1600 KC, and is mostly talk radio these days, but there are a few music stations too. The shortwave bands are still used and there are many stations from around the world that broadcast programs of news from their nation and their nation's point of view, local culture and music. You can find stations in the range of 5 MC to about 8 MC with ham bands just above 7 MC, more international stations between 9 MC and 10 MC, and still more between 11 MC and 12 MC. You can find listings of the frequencies and times of these broadcasts on the net.here is a link to one site  http://www.primetimeshortwave.com/  . The police band that falls between these areas, 1600 KC to 5 MC is pretty much dead for general listening. You can find the u. S. National Bureau of Standards time signal at 5.00 MC and 10.00 MC it is a good standard to check your alignment.
#3

Thanks Mike, yes I was aware of the AM broadcast. I assumed it was the band labeled "Standard Broadcast". It was the other three I wasn't sure about.
I also have another radio with the four bands on the dial, but instead of the band labeled "Police" it is labeled "Amateur". Would this be the same or more for the ham radio operator type of thing?
#4

The police band on these old set haven't been used by the police since before wwII. Nowadays it's all vhf and uhf fm. LW band is pretty useless short of a small ham band and a couple of navigational signals that are transmitted in Morse code. Bands that have Amateur markings still are ham bands and since the 80's a few more have been added.
These days there are a lot of modern devices that generate a lot of interference in the lw/mw/sw bands. Phone and laptop chargers are some of the worst offenders. They use what known as switch mode power supplies. They make buzzy noises all over the spectrum.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#5

Got it. Thank you.
#6

in the old Police band you will now find some Amateur frequencies, you can find a listing of them here, http://www.arrl.org/frequency-allocations . You will also find the amateur frequencies for bands in the longwave spectrum, and in the shortwave spectrum above the old "police band".
#7

Thanks Mike. I will search them out.
#8

Thanks for asking this question, I , too, wondered the same.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Restoration of the Canadian General Electric A-87
Thanks for your help Michael. In fact, this video is only an intermediate result. Later I had to apply another tinting l...RadioSvit — 09:01 AM
Restoration of the Canadian General Electric A-87
Great job on the cabinet. PS. In the US notation, "kenotron" refers to specific type of tubes; we call re...morzh — 08:24 AM
Part numbers to model cross
This document has at least some tables of models and parts used. Example: Choke 32-7572, used in 604 radio. Search f...morzh — 08:19 AM
Restoration of the Canadian General Electric A-87
I also checked all the radio tubes on my Hickok 530 tube tester. The 5Z3 kenotron turned out to be faulty, all the other...RadioSvit — 08:02 AM
Restoration of the Canadian General Electric A-87
Well... While the varnish is drying up, I started repairing the chassis... Of course I started by replacing the pa...RadioSvit — 07:12 AM
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM

[-]
Who's Online
There are currently 1158 online users. [Complete List]
» 2 Member(s) | 1156 Guest(s)
AvatarAvatar

>