Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Sonora RBU-175 Low Band Issues
#1

Hello Fellow Radio Heads. I have ventured from the world of Philcos to try and expand my knowledge of all radios in general. I have a Sonora RBU-175 that I have re-capped all but the bigger filter caps. The radio appears to be aligned just fine as any station above 950 comes in good and loud and appears to be dead on accurate. My issue is as soon as I go below 950, I seem to loose any type of reception. I get absolutely no type of sound......nothing. Is there a definitive line between upper and lower bands that I may be able to Isolate maybe a loose connection, Bad resistor or at this point.....ANYTHING, LOL. Thanks in advance for any help you can provide.

Jerry Gatewood
Philco 41-280 (121)
#2

Likely problem is that the plates of the tuning cap are shorting as the capacitor is meshed.
#3

You are a freaking Genesis. I have been sitting in front of this thing for 6 hours and I wound it down all the way and sure enough, I found a bent fin. Straightened it out and Bingo, Got tone all the way down. THANK YOU!!!!!!!!!!!!!!!!!!!!!!!!

Jerry Gatewood
Philco 41-280 (121)




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
PT 6 chassis screws size???
Hello bridKarl, that sounds right or maybe 8/32 . Sincerely Richardradiorich — 01:00 AM
PT 6 chassis screws size???
Have this done except for missing chassis screws. It looks like 1 inch 6/32 sheet metal screw may work but can anyone s...bridkarl — 10:32 PM
Philco model 38 code 121 not receiving signal.
Hello Stormlord, Well done on rewinding that coil it turned fairly good for your first one. Sincerely Richardradiorich — 09:12 PM
Philco model 38 code 121 not receiving signal.
Well here it is. It ain't pretty, but hopefully it'll work. I checked it with my DMM on continuity and it keeps and r...Stormlord5500 — 08:56 PM
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM

[-]
Who's Online
There are currently no members online.

>