1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Restoration Book?
SRv2
Junior Member
**
Posts: 27
Threads: 5
Joined: Mar 2024
City: BERTHOUD State, Province, Country: CO
#1

03-18-2024, 12:49 PM
Hi all,
Does anyone have a recommendation for a good general book on wood cabinet restoration techniques?  Or a website with good info, or youtube videos?  Hoping to improve my general knowledge and techniques.  
Thanks,
George
George - Berthoud, Colorado.  Learned tube receiver repair and troubleshooting in the Navy way back when, came back around to it as an old guy.  Re-learning all I can.  Doing my part to restore a few of these old gems.
(This post was last modified: 03-18-2024, 02:23 PM by SRv2.)
Find
Dan Walker
Senior Member
****
Posts: 377
Threads: 105
Joined: Jul 2011
City: Calgary, AB, CA
#2

03-19-2024, 10:06 AM
Here is some information about refinishing cabinets.
 I use this method  [with some variations]   and my cabinets come out very good.
     Here are a couple of photos of some of my cabinets.
 
https://www.antiqueradios.com/features/lacquer.html

Dan in Calgary


Attached Files Image(s)
                           
   Living in Calgary Alberta
Find
SRv2
Junior Member
**
Posts: 27
Threads: 5
Joined: Mar 2024
City: BERTHOUD State, Province, Country: CO
#3

03-19-2024, 10:19 AM
Hi Dan,
Thank you for this info, super helpful!  And your work looks incredible!  I really appreciate the link.
George
George - Berthoud, Colorado.  Learned tube receiver repair and troubleshooting in the Navy way back when, came back around to it as an old guy.  Re-learning all I can.  Doing my part to restore a few of these old gems.
Find
« Next Oldest | Next Newest »
Thread Closed




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM
Philco model 38 code 121 not receiving signal.
Good news everyone! I think I have found everything I need for rewinding the antenna coil primary. I found some pla...Stormlord5500 — 09:40 AM

[-]
Who's Online
There are currently 1885 online users. [Complete List]
» 2 Member(s) | 1883 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration