Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 316 schematic needed
#1

I recently received a Philco 316 code 126 radio. It was manufactured in Toronto so it’s a Canadian model. I did find one schematic on Nostalgia Air but it’s very fuzzy and hard to make out the values for the caps and resistors. It also doesn't contain a parts list which I find very helpful since I’m relatively new to this hobby.

Does anyone have a better copy of this schematic or possibly a parts list that they could post, or is there a US model that is the same as the Canadian model?

Appreciate any assistance.
#2

If it's the set I think it is the U.S model is a model 16, but then again there is typically a Code number as well as a model number. The 316 should be in the RCC manuals, which I think the radiocodegods site has, I don't think Pacifictv has Philco models, here are some better diagrams of the U.S versions on this site https://philcoradio.com/library/index.ph...ams-vol-1/

Regards
Arran




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2134 online users. [Complete List]
» 1 Member(s) | 2133 Guest(s)
Avatar

>