1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
New Acquisition - Philco 116B
wbaradio
Junior Member
**
Posts: 11
Threads: 6
Joined: Sep 2011
City: Chesapeake, VA
#1

09-23-2011, 08:43 AM
I just picked up a Philco 116B on the cheap this week along with an excellent, all original, and complete Crosely D25-GN dashboard radio. The "Big Mac Daddy" 116B is in very good condition and is pictured below. Of course I will have to replace that decorative grill cloth and the speaker could us a re-cone.
I have a question for the Philco experts... this 116B is missing the back two feet in that it "leans back" on the front two feet. I have not looked closely yet, but there appears to be two metal tubes still sticking out from the placement of the feet which I assume stuck through the missing back wood? Can you guys elaborate...?
Thanks,
Britt Abbott

Note from site admin: Sorry, but the photos which were attached to this post are no longer available.
Find
TA Forbes
Deviate Emeritus
*****
Posts: 2,353
Threads: 92
Joined: May 2010
City: Clayton, NC
#2

09-23-2011, 10:03 PM
Hello, nice find. The 116B is an excellent radio!

The tubes are part of the cushion assemblies that the chassis screws go through.

Contact Steve Davis, who is a member of the forum, and see if he could make the back feet for you. His workmanship is superior!
Find
« Next Oldest | Next Newest »
Thread Closed




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2182 online users. [Complete List]
» 1 Member(s) | 2181 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration