Opinions on pricing for Clarion AC-51
Posts: 16,582
Threads: 574
Joined: Oct 2011
City: Jackson
State, Province, Country: NJ
Someone (who I bought a radio from before) offered me to buy directly a Clarion AC-51 radio, a console, in a decent enough condition (cabinet and chassis).
It is a beautiful radio (a guy sent me some photos).
But the radio is not awfully abundant around, so I cannot size up the price by comparison.
Any opinions what a console (it is presumed it will need a restoration; on the photos the tubes are glowing so the power must be OK) like this should be worth?
Posts: 674
Threads: 146
Joined: Jun 2011
City: Elko,MN.
I sold one of these last fall minus the tubes for $45.00.
Cabinet was nice,chassis needed some work.
murf
Posts: 16,582
Threads: 574
Joined: Oct 2011
City: Jackson
State, Province, Country: NJ
I can tell you how much the guy wants for it (it's on e-bay). More than 10 times that.
Posts: 2,353
Threads: 92
Joined: May 2010
City: Clayton, NC
It's not worth 400.00. It's in nice shape, maybeuncommon, but it's not worth that.
Posts: 2,353
Threads: 92
Joined: May 2010
City: Clayton, NC
I noted that he had a reserve on it. Now that it has ended, do you know what the reserve was.
Also noted that in a previous listing his buy it now was 800.00. His sense of value for this set is greatly exaggerated.
Posts: 674
Threads: 146
Joined: Jun 2011
City: Elko,MN.
(04-26-2012, 07:32 PM)TA Forbes Wrote: It's not worth 400.00. It's in nice shape, maybeuncommon, but it's not worth that.
WHen I bought mine,I paid $15.00 for it.
Had no tubes and needed work on the power supply end of it.
Had a short somewhere in the B+.
Lots of rotten wires too.
murf
Posts: 2,353
Threads: 92
Joined: May 2010
City: Clayton, NC
Hello, Murf: did you ever get it working?
Posts: 16,582
Threads: 574
Joined: Oct 2011
City: Jackson
State, Province, Country: NJ
Well.....I'd say a radio like this one in a really nice condition could possibly be close to 200 bucks.
I bought a radio of him once; my next project; I saw the bids (enough of them) climb to 280, and the reserve was not met. When the radio did not sell, I asked him, and he said it was 350 (I gave him 300, judging by the bid history and my unwillingness to search flea markets for lower prices myself). Also he lived close to where I worked, a 20-minute drive, so I could pick it up (shipping a radio like this could cost a lot).
So, this time I suspect his reserve is even more.
I don't think is worth that much though.
SO far I did not ask him what his reserve was.
Posts: 674
Threads: 146
Joined: Jun 2011
City: Elko,MN.
(04-26-2012, 09:11 PM)TA Forbes Wrote: Hello, Murf: did you ever get it working?
Nope,
Sold it to a guy for $45.
Did not want to spend alot of time on it.
Posts: 4,950
Threads: 54
Joined: Sep 2008
City: Sandwick, BC, CA
This is someone who quite clearly has a delusional sense of value to say the least, maybe he's related to the weirdo in Whitby, Ontario? Clarion was a brand name for radios manufactured by the America Transformer Company or Amertran. I haven't heard or read anything bad about them but there isn't really anything unique or special about Clarion sets, they are just your typical 1929 to 32 TRF set with your typical string of 2.5 volt AC tubes, like a hundred other sets of the same era. On top of that they are a bit of an off brand so nobody is really seeking them out like a Zenith, or an Atwater Kent, or a Philco of course.
Typical TRF late 20s early 30s consoles don't usually crack the $125 mark in good original condition, and a lot less then that if they need cabinet work or have parts missing. The reason being is that they are all pretty similar, similar circuitry, similar cabinet styles, without reading the name on the escutcheon it's hard to tell them apart sometimes. I have a few myself and I doubt whether I paid more then $75 for any of them.
Regards
Arran
Posts: 16,582
Threads: 574
Joined: Oct 2011
City: Jackson
State, Province, Country: NJ
Thanks guys, at least I have an idea. I kind of was puzzled with the asking price, but did not know the real market value.
Users browsing this thread: 1 Guest(s)
|
Recent Posts
|
Philco Model 38-7: what caps & resistors do fail typically?
|
Since you stated earlier, you have a console 38-7XX. They also had a 38-7T (table), and 38-7CS (chairside). A very nic...GarySP — 01:18 PM |
Part numbers to model cross
|
That I wouldn't know, but sometimes the radio document itself shows one, same as the capacitor cans' etc pinouts.morzh — 12:46 PM |
Part numbers to model cross
|
Thank you morzh, that is exactly what I was looking for. Now , is there some where that shows pinouts for Philco power ...Jim Dutridge — 11:37 AM |
Restoration of the Canadian General Electric A-87
|
Thanks for your help Michael. In fact, this video is only an intermediate result. Later I had to apply another tinting l...RadioSvit — 09:01 AM |
Restoration of the Canadian General Electric A-87
|
Great job on the cabinet.
PS. In the US notation, "kenotron" refers to specific type of tubes; we call re...morzh — 08:24 AM |
Part numbers to model cross
|
This document has at least some tables of models and parts used.
Example: Choke 32-7572, used in 604 radio.
Search f...morzh — 08:19 AM |
Restoration of the Canadian General Electric A-87
|
I also checked all the radio tubes on my Hickok 530 tube tester. The 5Z3 kenotron turned out to be faulty, all the other...RadioSvit — 08:02 AM |
Restoration of the Canadian General Electric A-87
|
Well... While the varnish is drying up, I started repairing the chassis...
Of course I started by replacing the pa...RadioSvit — 07:12 AM |
Philco Model 38-7: what caps & resistors do fail typically?
|
Hello Martin,
Welcome aboard our little community what great Model 38-7
Sincerely Richardradiorich — 12:30 AM |
Philco Model 38-7: what caps & resistors do fail typically?
|
Welcome to the Phorum Martin.
I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM |
Who's Online
|
There are currently 1512 online users. [Complete List] » 1 Member(s) | 1511 Guest(s)
|
|
|

|