Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Station tabs for 39-116 and Mystery Remote
#1

Hi-
I'm looking for some station call tabs to complete the restoration of my 39-116 console and Mystery Remote.

Any assistance you can offer will be greatly appreciated.

Thanks,
Lew
#2

Hi Lew

Barring the discovery of a new-old-stock set of original 1939 call tabs, you can make your own on your PC. Simply measure the size needed and go from there.

The tabs used on the radio's dial escutcheon are larger than call tabs used on other Philco models (those that do not have Mystery Control). So, unless you were lucky enough to run across an original set on eBay, you will probably have to make your own.

Tan lettering against a dark background will work well for the tabs which go on the radio's dial escutcheon. For the actual Mystery Control escutcheon, use dark brown letters against a tan background.

--
Ron Ramirez
Ferdinand IN
#3

Thanks for the advice, Ron.
I was hoping to stumble across a set of NOS tabs (or just 8 individual tabs), but barring that, I will have to make my own as per your suggestions.

Much obliged,
Lew




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2050 online users. [Complete List]
» 1 Member(s) | 2049 Guest(s)
Avatar

>