Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco 81 -1933 early --Speaker Grill cloth
#1

 Ok,,were can I get Speaker Grill cloth,,,,I have a original piece that was on there,,,,it looks, close to the Small Herringbone Weave cloth,,,that Richmond Design Inc. has,,,but,,that is not it . Is there someone else out there, whom may have what I looking for. Thank You for all you help and time,,,,Ken
#2

Do you have a picture of it?
#3

Kenneth's cloth may be your best option I think. Check RadioDaze and there are some other folks that sell on ebay you can check.
#4

I think Kenny's Small Herringbone pattern looks fine and I would not hesitate to use it in any of my sets which originally had that pattern.

You have to keep in mind that Radio Grille Cloth Headquarters is gone, out of business...and they won't be back...and we will probably never have such a large selection of cloth patterns available to us ever again.

--
Ron Ramirez
Ferdinand IN
#5

  Well,,Thank you all for the input ,,,,,I will have to go with what Mr. Ron,,says,,,,,I had to hear it from the most educated one's on this subject,,,,Thank You all Again




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
PT 6 chassis screws size???
Hello bridKarl, that sounds right or maybe 8/32 . Sincerely Richardradiorich — 01:00 AM
PT 6 chassis screws size???
Have this done except for missing chassis screws. It looks like 1 inch 6/32 sheet metal screw may work but can anyone s...bridkarl — 10:32 PM
Philco model 38 code 121 not receiving signal.
Hello Stormlord, Well done on rewinding that coil it turned fairly good for your first one. Sincerely Richardradiorich — 09:12 PM
Philco model 38 code 121 not receiving signal.
Well here it is. It ain't pretty, but hopefully it'll work. I checked it with my DMM on continuity and it keeps and r...Stormlord5500 — 08:56 PM
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM

[-]
Who's Online
There are currently no members online.

>