Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco tuning capacitor
#1

Hi every one I am new to this hope I am doing it right here goes am trying to repair philco mod 41-260 tuning cap hanging up I have tryed about all i know doe;s any one know where I can get one or have it repaired
Thanks Tom ps p/n 31-2481R
#2

Welcome to the Phorum!
Icon_wave

I moved this to the restoration section to see if any one can offer sdvice for a repair. If you want to see if any one has a spare, put a post on the wanted section.
#3

Tom

Welcome.

Two requests:

1. Could you please use some punctuation, it is a bit hard to read one long sentence with no commas whatsoever.
2. What does "tuning cap hanging up" mean? Tuning cap is not a computer. We can make guesses as to what you mean, but it is better if you explain the symptoms.

Start from the beginning, what was done to the radio (like, was it re-capped etc), what it does when you do something to it (power up, sound, tuning, performance), etc.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#4

Mike;
  I can only take a guess but it sounds like the tuning capacitor might be seized up, but I too will await clarification from the original poster to find out if that is what he meant. Short of severe corrosion or mechanical damage there isn't really a lot that can go wrong with a tuning cap, usually it's a matter of cleaning and new lubrication in the bearing points.
Regards
Arran




Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2273 online users. [Complete List]
» 4 Member(s) | 2269 Guest(s)
AvatarAvatarAvatarAvatar

>