Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Knob Labeling?
#1

I am trying to determine if the on/off, volume, etc., knobs were originally labeled on my Model 507 Radiobar? I seem to have gotten mixed answers to this question. I have purchased the "Radiobar" front panel decal from Radio Daze and would like to have that, and any other correct decals installed by my cabinet restoration shop. 
I honestly cannot remember if the knobs were labeled when I first got the radio almost 50 years ago.
Your thoughts?
#2

No, the knobs had no decals above them originally. The only decal on the front panel would have been the "Radiobar" decal with "PHILCO" underneath that.

--
Ron Ramirez
Ferdinand IN
#3

Thank you Ron. That seems to be the general consensus over at Radio Daze as well.
Although it does seem odd that Philco would not have labeled these controls originally.
Best, Greg




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
So one last question before I finish this radio. Regarding the speaker and output transformer. I salvaged the original o...Stormlord5500 — 09:31 AM
462ron
It’s on the bottom of the homepage of our Philcoradio.com homepage! Ron462ron — 07:20 AM
Model 70 Cabinet Trim
Steve might have some trim left. Not sure he is making anything.morzh — 06:12 AM
Model 70 Cabinet Trim
Hello musar, First all welcome to the forum and yes that is true that steve stopped making trim . Sincerely Richar...radiorich — 12:13 AM
Model 70 Cabinet Trim
I have recently come into possession of a Model 70.  The trim around the base needs to be replaced.  If this were years ...musar — 12:07 AM
philcorepairbench.com - shadow-meter
Anyone know of a way to recover these files from the repair bench? Thanks. fenbach — 11:16 PM
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM

[-]
Who's Online
There are currently 690 online users. [Complete List]
» 3 Member(s) | 687 Guest(s)
AvatarAvatarAvatar

>