Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Cleaning a turntable stylus?
#1

This may be a little off-topic, but lately, I've been struggling with stuttering from my vinyl. I've come to the realization that maybe I need to clean my stylus and cartridge, but I see quite a few different opinions on the topic.

https://soundwiz.net/blog/clean-turntable-needle/
This article kinda hinted me towards getting either some sort of sponge or some sort of gel solution rather than just a brush.

What are your guys take on cleaning a turntable and its stylus? I'd love a few opinions.
#2

I always like to start with a good inspection of the needle. Then you know what you're up against. Of course I have access to magnifying equipment.
#3

Rasmus

are you talking about modern or vintage players?

If modern,

1) you placed in in a wrong forum - this is for Philco restorations. 2) You might go in the "Vintage Hi-Fi" one and post it there.

Even though it is against the policy, I'd say that the best advice for modern turntables and cartridges you will get on AudioKarma or similar places. We here more about really antique things.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.




Users browsing this thread:
[-]
Recent Posts
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM
Philco model 38 code 121 not receiving signal.
I use a pair of Mastercraft brand DMMs from Canadian Tire, from what I read most of those DMMs use the same main chip re...Arran — 02:36 PM
Philco model 38 code 121 not receiving signal.
Thank you sir. Yes I feel good and also relieved because this one's been weighing on me a bit.Stormlord5500 — 11:18 AM
Philco model 38 code 121 not receiving signal.
It feels good don't it? Good luck on the rest.Paul Philco322 — 11:06 AM
Philco model 38 code 121 not receiving signal.
I've reinstalled the coil. Now IT'S ALIVE!!!!!! I fired up my TinySA on signal generator mode and set it to 1400Kc and ...Stormlord5500 — 11:01 AM
Philco model 38 code 121 not receiving signal.
Yes, Walmart, right up there with Fluke.RodB — 11:00 AM
PT 6 chassis screws size???
it certainly won't be metric! SAE threads were all that was known then. Take care, - GaryGarySP — 10:58 AM
Philco model 38 code 121 not receiving signal.
I think this thing is way more accurate than my Walmart DMM. :DStormlord5500 — 08:19 AM
Philco model 38 code 121 not receiving signal.
Thankyou for the kind words sir. I double checked it with my component tester and it read 2.7 ohms at .02mH.Stormlord5500 — 08:14 AM

[-]
Who's Online
There are currently 2774 online users. [Complete List]
» 3 Member(s) | 2771 Guest(s)
AvatarAvatarAvatar

>