Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

RCA Model M101 M104 M108 auto radio 1934
#1

First let me say that the passing of Ron Ramirez was noted with sadness on the website of the New Zealand Vintage Radio Society. R.I.P. Ron 
I have come across an RCA Model 101 104 108 auto radio.I have been able to identify it thanks to info gleaned from the Phorum . Thanks everyone.It has been modified and a speaker box grafted onto the front. Does anyone know where I can see a photo of it as original? Also  was this set an aftermarket model or was it a set installed in particular makes of car?  Any help appreciated. Thanks everyone.
#2

Some links that I hope will help. Good luck David  https://www.radiomuseum.org/r/rca_m101.html       https://www.retroradioshop.com/pages/ide...rca-victor        http://www.rfcafe.com/references/radio-c...e-1935.htm




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
philco predicta
Hi CGL18, First off, welcome to the Philco Phorum. I have not worked on a TV for a while but here are some givens: ...MrFixr55 — 08:22 AM
Another amp build - here I go again!
Sweet! I actually have a Dynaco Mark 4 that I had been running with 6L6s with no mods. Seemed to my 14-year-old head a...MrFixr55 — 12:57 AM
PT-6 finished!!
Hi Gang, Tube heaters are not "Ohmic" devices (that maintain specified resistance over wide temperature, c...MrFixr55 — 12:03 AM
Electrolytic restuffing/internals
Look here: Philco-F676-124 Vlad95 — 08:02 PM
PT-6 finished!!
Well the 35Z3 doesn't have a tap on the tube heater for a pilot light, so in this set they have the dial lamp paralleled...Arran — 06:21 PM
Electrolytic restuffing/internals
Thanks. I think I try to cut this as suggested. I don’t have a lathe, but I do have a tap and die set. I am going to see...bridkarl — 04:46 PM
Another amp build - here I go again!
Hey all! Well, I guess that with what I learned from my last build, it's time to move up the ladder another rung and tak...TV MAN — 04:38 PM
Electrolytic restuffing/internals
There are various ways to handle this, one is to cut near just above that rolled in area is near the bottom, using the r...Arran — 04:36 PM
philco predicta
If you have a television signal generator (a must-have for TV repair) and an oscilloscope (the same), then this problem ...RadioSvit — 04:23 PM
HiFi (Chifi) tube amp build - but my own design.
Thanks Rod for the offer but I don't think those would work. There's some differences in the sizing and mounting holes b...TV MAN — 03:13 PM

[-]
Who's Online
There are currently 303 online users. [Complete List]
» 2 Member(s) | 301 Guest(s)
AvatarAvatar

>