Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

46-1209 dynamic reproducer
#1

After all these years my dynamic reproducer needs to be replaced. I have to keep moving the needle to around to make it work and now it just wont work. Is it possiable to find a replacement or have the one I have repaired?
#2

Hi

It seems like Gib at West-Tech told me once that those "dynamic" cartridges can't be repaired, but it would be worth asking to be sure:

http://www.west-techservices.com/

If it can't be fixed, you will have to replace it with a magnetic cartridge (which is what the "dynamic" cartridge really is). Don't forget that 78 rpm stylus! You can still buy Stanton cartridges and 78 rpm styli from some vendors. You'll need to deal with tracking weights, also, which is beyond my area of "expertise." Icon_smile

--
Ron Ramirez
Ferdinand IN
#3

Thanks Ron for the advise. I'll check around for a Stanton.
I also would like to say thanks for all your advise on doing a recap. I know I asked lots of rookie questions. this radio was a Christmas present to my mom back in 46 and the last thing I wanted to do was short the whole thing out. The recap went fine and it plays stronger than ever (execpt the radio).




Users browsing this thread:
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM
Philco model 38 code 121 not receiving signal.
I use a pair of Mastercraft brand DMMs from Canadian Tire, from what I read most of those DMMs use the same main chip re...Arran — 02:36 PM
Philco model 38 code 121 not receiving signal.
Thank you sir. Yes I feel good and also relieved because this one's been weighing on me a bit.Stormlord5500 — 11:18 AM
Philco model 38 code 121 not receiving signal.
It feels good don't it? Good luck on the rest.Paul Philco322 — 11:06 AM
Philco model 38 code 121 not receiving signal.
I've reinstalled the coil. Now IT'S ALIVE!!!!!! I fired up my TinySA on signal generator mode and set it to 1400Kc and ...Stormlord5500 — 11:01 AM
Philco model 38 code 121 not receiving signal.
Yes, Walmart, right up there with Fluke.RodB — 11:00 AM
PT 6 chassis screws size???
it certainly won't be metric! SAE threads were all that was known then. Take care, - GaryGarySP — 10:58 AM
Philco model 38 code 121 not receiving signal.
I think this thing is way more accurate than my Walmart DMM. :DStormlord5500 — 08:19 AM

[-]
Who's Online
There are currently 1264 online users. [Complete List]
» 3 Member(s) | 1261 Guest(s)
AvatarAvatarAvatar

>