Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Proper line cords for different model years
#1

Given that over the years many line cords have been changed out on older Philco models, I wonder what is original and correct. When did Philco change from braided cloth covered AC line cords to parallel zip cord?

I am thinking maybe 1937? I have a 1936 610B which appears to have an original cloth cord. Any newer Philco seems to have zip cord?

I have a 37-9 chassis which has a crumbling rubber zip cord, but not sure if original.
#2

Philco made the changeover during the 1937 model year. Some 1937 models have been found with cloth-covered AC cord, but most seem to have had rubber. As was Philco's wont, they used up their old stock of cloth-covered AC cord before making the switch to rubber. All 1936 models appear to have had cloth, and all 1938 models had rubber.

--
Ron Ramirez
Ferdinand IN
#3

Thanks Ron, that confirms my thoughts.

The other thing I wondered about is the type of plugs used with the cords. The cloth cords always seem to have the screw terminal bakelite plugs attached, but am not sure if Philco always used molded on plugs with rubber cords?




Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2138 online users. [Complete List]
» 1 Member(s) | 2137 Guest(s)
Avatar

>