Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco 70 and others rescued
#1

Recently acquired this beauty from an auction with several radios that survived a fire.
Upon wipedown and cleaning lightly with Murphy's, this beauty looks pretty good.
Upon close inspection of the cabinet, there are definitely some battle scars.
The chassis looks to be pretty original with the exception of later 40s/50s  electrolytics.
I will be digging into this soon.
Also picked up a 60MB, a JR 80, a 37-60 and a 38-40T as well as two Gloritone 26 radios.
Got the Gloritones to work, the 37-60 sounds nice, but lost her face paint in the fire and the 60MB sounds decent also with new electrolytics..
The jr and the 38-40T are going to require a bit of attention.
I got a bit lucky that transformers, speaker coils and antenna coils are good in all these except the 38-40 which suffered a bit of melty from the fire

Fun work ahead for sure.
I will post as issues arise
Icon_smile
Steve


Attached Files Image(s)
   
#2

Pretty Good looking case.....hope the electrics are as good.

Paul

Tubetalk1
#3

The heat baked the front, not too bad, it's a miracle the cloth did not ignite, bring it back to life, fun radios.




Users browsing this thread:
[-]
Recent Posts
Delco car radio Peko vibrator converstion issues
Rich, There is an Australian website (Cool386.com) that has much useful info regarding repair and restoration of vibr...Joe Rossi — 07:29 PM
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM

[-]
Who's Online
There are currently 3469 online users. [Complete List]
» 3 Member(s) | 3466 Guest(s)
AvatarAvatarAvatar

>