Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

HELP for identifying
#1

Hi,
Need help for identifying this model, probably PHILCO, may be model 51 538 (1951) but clock is missing. Stamped on chassis : model 50 52 5121
Is it correct ?
Thanks for interest and replies,
megawave,
French collector
Icon_smile
[Image: http://img222.imageshack.us/img222/1449/chassis2.jpg]

Uploaded with ImageShack.us
#2

It's right there in the photo, black ink-stamped on the rear apron of the chassis.

MODEL 50-52? CODE 121 Last digit obscured. A 1950 model.

Could be a 50-520, 522, 524, 526, or 527.

Chuck
#3

Hi Chuck, thank you for reply.
Photo better below, I can read Model 50-527. Is it Correct ?
Thanks for interest and reply.
Sincerely,
megawave


[Image: http://img64.imageshack.us/img64/1933/philco50527.jpg]

Uploaded with ImageShack.us
#4

Yep, 50-527, Code 121.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently no members online.

>