Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

38-7 grill cloth dimensions?
#1

Hi all! I searched the forums, but couldn't find the answer to what I'm looking for. I sent the cabinet for my 38-7 out to be refinished but forgot to measure the speaker panel for the dimensions for new grill cloth. Can anybody help me out? Also, I've seen a couple of different online advertisements for grill cloth. Anybody have good experiences with any particular vendor? Thanks!
Dave
#2

Is this a console, chairside, or table model?

Radio Grille Cloth Headquarters is the best place to purchase grillecloth.
http://www.grillecloth.com/

--
Ron Ramirez
Ferdinand IN
#3

Sorry - it's the console model.
Dave
#4

I don't own one of these, but Radio Grille Cloth Headquarters only sells this cloth in three sizes: 24" x 25" (for one console), 52" x 24" (for two consoles), 44" x 52" (for four consoles).

The pattern number you need is #41, by the way.

--
Ron Ramirez
Ferdinand IN
#5

Thanks, Ron - I appreciate the quick response!
Dave




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 3921 online users. [Complete List]
» 1 Member(s) | 3920 Guest(s)
Avatar

>