Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Unidentified Philco Cabinet.
#1

Hi all,

In my tradition of finding unusual philcos every now and again, here is a cabinet a customer brought. I have a feeling its another manuf that was converted to a philco but I cant even find the front dial plate with its V shaped pattern in the Philco book. No tags or stamps inside the cabinet at all. I looked thru Stein and cant find the cabinet under another manufacturer there either.

Ideas??

Thanks

Keith
(trying to upload the images, not sure if they went in... Ill try again if they don't)

Note from site admin: Sorry, but the photos which were attached to this post are no longer available.
#2

Hi Keith

No, this cabinet is not an original Philco factory issue. It may very well be an aftermarket cabinet made by a third party manufacturer, but it did not come from the Philco factory.

--
Ron Ramirez
Ferdinand IN
#3

I agree, it's not a Philco cabinet, I'm not sure what it was originally but that panel and escutcheon is from a 1934-35 vintage set (probably from a Philco MX type cabinet) while the cabinet is from between 1930-33 vintage. For some reason it reminds me of a Stromberg Carlson from that era but I don't think that it is.
Regards
Arran
#4

Thanks, That confirms what I thought,... and ya know, I thought Stromberg Carlson too!
Its a mystery cabinet... a nice one, but collector value with the Philco stuff in it is nil. (and the Philco stuff is missing anyway)

Thanks

Keith




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
RCA WV-98c
If this is R22, check the voltage on the wiper (86V). If this is R33, see if the lower pin indeed connected to GND, the ...morzh — 02:29 PM
Philco 38-2 Low Volume
Both sch, the one you showed in the beginning and the one I see on Nostalgia, show 40K for the 2nd audio plate.morzh — 02:25 PM
Model 96 cabinet veneer
I can't figure out what the first step is, let alone the final step. I have tried copying pictures from my hard drive a...TGLager — 01:40 PM
Philco 38-2 Low Volume
I managed to get some more time on this. Hi Mr. FixIT, The radio has been recapped. Many of the resistors were rep...dconant — 01:39 PM
Philco 38-2 Low Volume
Thanks guys for the help. I started looking at these points but I have to quit for the day. I will be looking into this ...dconant — 12:23 PM
RCA WV-98c
Check out this crazy zero pot operation. Touching it drives it crazy. Its rubber tipped. Also the 6al5 has no negative v...daveone23 — 12:08 PM
Philco 38-2 Low Volume
If you check all of that and still have a problem (my first inkling would be one of the 6F6s) then look at the 6J5 phase...RodB — 10:44 AM
RCA WV-98c
Those will probably depend on teh switch combination. Could you list some that you see, their values and what they sh...morzh — 10:26 AM
Model 96 cabinet veneer
You are probably skipping the final step. Once you select the photos you want and they get downloaded, the system assign...RodB — 09:36 AM
RCA WV-98c
At this point, there is no input, just internal voltages Which are incorrect and not sure what they should be.daveone23 — 09:15 AM

[-]
Who's Online
There are currently 1229 online users. [Complete List]
» 3 Member(s) | 1226 Guest(s)
AvatarAvatarAvatar

>