Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

It's a beast, but the price was right.
#1

I missed out on the Philco this guy had, but dragged home this Zenith 12H090Z for a low price. Needs a tone arm and of course has all that wonderful, crumbling rubber wire to deal with. He seemed like a nice young man and he said he would try to contact me about any other radios he ran across at auctions in his area. Both the Philco and this radio came from the same home that was auctioned off.

   

   

No matter where you go, there you are.
#2

wow really nice Icon_clap
#3

Thanks. At least it is in better shape than the one I had years back before I joined the Phorum. Any tips on how to best preserve the photo finish on these? It has 'alligatored' some from temperature changes over the years, but isn't peeling and is still mostly intact. I know getting it in a climate controlled environment is the first step.

No matter where you go, there you are.
#4

Very nice. Good luck with it
#5

Wow....Icon_thumbupIcon_thumbup

Don't let it fall on you! You will have to use a floor jack or a chain hoist to get it up off the floor.
#6

I have one in the shop right now. Someone put coasters on it.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#7

Looks nice, and will sound and look great by next spring, probably.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 3908 online users. [Complete List]
» 1 Member(s) | 3907 Guest(s)
Avatar

>