Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Scott Philharmonic
#31

Been playing this radio for many months now. It produced a bit of static periodically so i finally decided to see if I could find the cause. As mentioned previously, this radio had been worked on previously. I restuffed all of the original caps that remained, leaving several older Solar Sealdtite and a couple of Sprague Black Beauties that had been replaced many years ago. I replaced all of those. Unfortunately, I had nothing to restuff to make it look original. So now there are quite a few of the beauteous Chinese yellow caps under there! It has been playing for several hours now with no hint of static. Can't trust any cap (except mica) that's over a few decades old. I guess the the Solar company went out of business in about 1949, making the solar caps in this radio at least 60 years old. Evidently huge inventories at the time found their way into the inventory of parts suppliers and were being sold well into the '70's as new caps. Little doubt that is where these came from. All capacitors and a few resistors have now been changed in this radio.
#32

Rob

Have you cleaned the tuning cap?

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#33

Yes I did, Mike. No problem there. Still no static since I replaced the Solar's. I suspect that one of those or the Black Beauties were the culprits.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 38-2 Low Volume
Both sch, the one you showed in the beginning and the one I see on Nostalgia, show 40K for the 2nd audio plate.morzh — 02:25 PM
Model 96 cabinet veneer
I can't figure out what the first step is, let alone the final step. I have tried copying pictures from my hard drive a...TGLager — 01:40 PM
Philco 38-2 Low Volume
I managed to get some more time on this. Hi Mr. FixIT, The radio has been recapped. Many of the resistors were rep...dconant — 01:39 PM
Philco 38-2 Low Volume
Thanks guys for the help. I started looking at these points but I have to quit for the day. I will be looking into this ...dconant — 12:23 PM
RCA WV-98c
Check out this crazy zero pot operation. Touching it drives it crazy. Its rubber tipped. Also the 6al5 has no negative v...daveone23 — 12:08 PM
Philco 38-2 Low Volume
If you check all of that and still have a problem (my first inkling would be one of the 6F6s) then look at the 6J5 phase...RodB — 10:44 AM
RCA WV-98c
Those will probably depend on teh switch combination. Could you list some that you see, their values and what they sh...morzh — 10:26 AM
Model 96 cabinet veneer
You are probably skipping the final step. Once you select the photos you want and they get downloaded, the system assign...RodB — 09:36 AM
RCA WV-98c
At this point, there is no input, just internal voltages Which are incorrect and not sure what they should be.daveone23 — 09:15 AM
Philco 38-2 Low Volume
Hi DConat, Generally, the lower the plate voltage the less negative the grid voltage has to be. Since the plates an...MrFixr55 — 09:27 PM

[-]
Who's Online
There are currently 1161 online users. [Complete List]
» 2 Member(s) | 1159 Guest(s)
AvatarAvatar

>