Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Radio Mystery
#1

Hello,

I purchased a 1948 International KB 1 pickup truck that has what I believe to be a philco radio in the dash. Attached is a picture of the control unit, I do not have the main unit. I would like to restore the truck to exactly how it was. What is the model of this unit? Does anyone have a picture of the correct main unit that would have been used with this control unit? Any help would be greatly appreciated.

Thank you in advanced,
Thomas


Attached Files Image(s)
   
#2

Welcome to the Phorum!
Icon_wave

I can't answer your question but hopefully someone else might be able to.

update:  for what its worth, that control panel sure is similar (though not identical) to the  Philco CT-11 car radio that went into 1936 Chryslers (according to Ron's chart).  The link is to a current ebay item just for reference.  I would bet that the radio was an add-on and might not be a 1948 radio (just guessing though).  

update#2:  the other item that seems to pop on 1947 International Truck up when you google around is Philco's UN6 100 radio which is not like your photo at all. 
#3

Thank you Bob,

I think all the radios for international were aftermarket. My truck also has a mopar heater so it might be possible that the radio was supplied by the same dealer. The CT-11 looks very similar but i think it is upside down based on here the needle is.

Thomas
#4

  I believe that removing the head unit from the dash would probably answer a few questions, like who made the unit and whether someone drilled and cut holes in the dash to fit it in there. The other radio linked to on fleabay isn't an I.H factory radio either, it's a generic aftermarket under dash unit, such units were marketed by many radio manufacturers to fit into older cars or trucks, some were self contained and others were two piece with the tuner in one box and the amplifier, speaker, and power supply in another box.
Regards
Arran
#5

Through further research I believe my truck was equipped with a Philco C-1452 or one very similar because of the mounting bracket on the firewall that allows the radio to be hung from. If anyone can provide me with more information or a location of one of these radios for sale it would be greatly appreciated.

Thank you
Thomas
#6

http://www.nostalgiaair.org/pagesbymodel...013949.pdf

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 38-2 Low Volume
Both sch, the one you showed in the beginning and the one I see on Nostalgia, show 40K for the 2nd audio plate.morzh — 02:25 PM
Model 96 cabinet veneer
I can't figure out what the first step is, let alone the final step. I have tried copying pictures from my hard drive a...TGLager — 01:40 PM
Philco 38-2 Low Volume
I managed to get some more time on this. Hi Mr. FixIT, The radio has been recapped. Many of the resistors were rep...dconant — 01:39 PM
Philco 38-2 Low Volume
Thanks guys for the help. I started looking at these points but I have to quit for the day. I will be looking into this ...dconant — 12:23 PM
RCA WV-98c
Check out this crazy zero pot operation. Touching it drives it crazy. Its rubber tipped. Also the 6al5 has no negative v...daveone23 — 12:08 PM
Philco 38-2 Low Volume
If you check all of that and still have a problem (my first inkling would be one of the 6F6s) then look at the 6J5 phase...RodB — 10:44 AM
RCA WV-98c
Those will probably depend on teh switch combination. Could you list some that you see, their values and what they sh...morzh — 10:26 AM
Model 96 cabinet veneer
You are probably skipping the final step. Once you select the photos you want and they get downloaded, the system assign...RodB — 09:36 AM
RCA WV-98c
At this point, there is no input, just internal voltages Which are incorrect and not sure what they should be.daveone23 — 09:15 AM
Philco 38-2 Low Volume
Hi DConat, Generally, the lower the plate voltage the less negative the grid voltage has to be. Since the plates an...MrFixr55 — 09:27 PM

[-]
Who's Online
There are currently 1155 online users. [Complete List]
» 2 Member(s) | 1153 Guest(s)
AvatarAvatar

>