Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Need pic of LO section for 16B (5 band)
#1

Can someone provide me a clear hi-res pic of the LO section of a 16B Code 121 (5 band), concentrating on lead dress? There seems to be some very critical lead dress in that area, and I want to make sure I have everything the way it needs to be.

TIA
#2

Brenda Ann,
This YouTube poster (Lockemeister) has a large number of videos on a 16B restoration. Maybe somewhere in those you'll be able to stop the video at an appropriate spot and see what you need. Probably lotsa work with marginal results so hopefully someone else will have a better, higher res shot.
http://www.youtube.com/watch?v=Vgh6-NbT1HI

...and from another site this shot of the entire bottom of a chassis http://canadianvintageradio.com/wpsite/w...768%5D.JPG (from http://canadianvintageradio.com/cvrs-for...completed/ )




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 3940 online users. [Complete List]
» 1 Member(s) | 3939 Guest(s)
Avatar

>